Tag Archives: WWVB

WWVB Atomic Clock Receiver Driver for Teensy 3/4 (MAS6180C)

Posted on February 2, 2024 by Dan TheMan

I have finally gotten around to wrapping up my driver for the Canaduino 60kHz WWVB clock receiver breakout board I purchased last fall. Information on assembling and testing the breakout board can be found here. In that post I discuss … Continue reading →

Posted in c-electronics, c-teensy | Tagged | Leave a comment

WWVB Antenna Alignment Really does MATTER!

Posted on January 8, 2024 by Dan TheMan

I spent a little time in South Texas, so I took my WWVB receiver with me to mess with while there. Being on the East side of the Rockies makes a huge difference in receiving the WWVB signal from Fort … Continue reading →

Posted in c-electronics | Tagged | Leave a comment

Emulating WWVB signal to Test CANADUINO 60kHz WWVB Atomic Clock Receiver (V3) – Breakout Board for MAS6180C

Posted on October 25, 2023 by Dan TheMan

Just a quick note in my attempt to receive the WWVB time signal and set my microcontroller’s clock based on that time: I was way too optimistic about being able to receive a readable signal from WWVB. Not only would … Continue reading →

Posted in c-electronics | Tagged | 1 Comment

Assembling and Testing CANADUINO 60kHz WWVB Atomic Clock Receiver (V3) – Breakout Board for MAS6180C

Posted on October 14, 2023 by Dan TheMan

I recently ordered a WWVB receiver from CanAduino. This breakout board allows you to receive date/time transmissions from the WWVB radio site in Fort Collins, CO. I have kind of an idea I might use this for future projects needing … Continue reading →

Posted in c-electronics | Tagged | 1 Comment